Page: 4/4
Invisible Reader Installation Instructions
October 2015 Rev 1.3
Reader Wiring
In Frame or In Door Mounting
1.
Use the attached cutout drawing template to make a proper cutout in the door frame or door (as applicable).
2.
Install the mounting tab into the door frame or door (if applicable)
3.
Wire the reader module to the access control panel.
4.
Screw the reader assembly to the mounting tabs or to the door or frame.
Troubleshooting
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
The reader does not recognize
a card/tag (no beep, no LED
flash).
1. One or more of the readers’
wiring connections are incorrect.
Power down the reader/access panel and check that
your wiring is correct.
2. The reader is not receiving proper
power from the access panel.
Measure the voltage at the reader. It should be
b5 VDC and +14 VDC.
3. The reader is mounted too close
to a device that radiates
electromagnetic interference.
If possible, install the reader in a different location or
move any other electronic devices away from the
reader.
4. You are using an incorrect type of
card.
Make sure you are using an access card that is
compatible with the reader.
Invisible Reader is compliant with the following organizations:
FCC compliance statement: This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference; and
(2) This device must accept any interference received, including interference that may cause undesired operation.
