Zodiac Link
Page 18 of 32
Operator Guide
June 2012 • Rev. 1.2
1.
Press
1
from the ADMIN menu.
2.
Confirm by pressing
1
(YES) or
2
(NO).
3.
If YES a
PIN
(
see Glossary
p. 26) will be issued for the user you are
adding. You can either:
4.
Press
1
(ACCEPT) to accept this PIN. Record the PIN.
5.
Press
2
(CHANGE) to change your PIN. Enter a PIN and press
ENT.
Record the PIN. NOTE:
6.
If NO you will return to the ADMIN menu.
7.
You will be prompted if you want to issue a
Bypass Number
(
see
Glossary
p. 26). Press
1
(YES) or
2
(NO).
8.
If YES, enter any available 5- to 8-digit bypass number and press
ENT
.
NOTE
: a longer bypass number is more secure and harder to guess.
9.
If NO, you will proceed to step 10.
10.
You will be prompted to enter a
User ID
(
see Glossary
p. 27). In the
case where the user has an existing ID number (i.e. cards/keys) you
should use that number (as long as it is in the range of 1-65,000).
(NOTE: this step is skipped if in DCM mode).
11.
You will be prompted to enroll a primary finger.
12.
Press
1
(YES) or
2
(NO).
13.
If YES, place a finger on the fingerprint scanner when it turns on.
When the message “Remove and Verify” appears on the display,
remove and replace the finger on the scanner.
14.
(i) If NO and a bypass number was entered in Step 7 above, the
enrollment process is complete.
(ii) If no bypass number was entered in Step 7, the enrollment process
is cancelled. You must specify a bypass number OR enroll a Primary
Fingerprint in order to be enrolled.
15.
If you enrolled a primary finger, you will be prompted to enroll a
Backup Finger
(
see Glossary
p. 26) for the user. Press
1
(YES) or
2
(NO).
16.
If YES, place an alternate finger on the fingerprint scanner when it
turns on. When the message “Remove and Verify” appears on the
display, remove and replace the finger on the scanner.
17.
If NO, there will not be a backup finger enrolled.
18.
Upon successful completion the user will be added. The user will also
be replicated to all other Slave Readers if the readers are configured to
use the RS-485 bus.
