How to use the 3M Adhesive Mount:
I.
Loosen the
(c) locking ring
on the suction mount and pull the
(e) magnetic
connector
out.
ii. Next, loosen the
(c) locking ring
from the 3M adhesive mount, and plug the
(e) magnetic connector
into the 3M adhesive mount.
iii. Clean the installation area on the windshield and peel off the plastic covering.
Adhere it to the windshield.
Loosen
Tigten
3. ATTACH THE MOUNT TO THE WINDSHIELD & START RECORDING
Remove the protective plastic film and select a location on the windshield where
won’t distract you. Then, put the suction mount in place.
Release the
(b) locking lever
from the mount by pulling down on it. Hold the
suction mount in place and press against the window. While holding it in place,
pull the
(b) release lever
back to lock the mount.
it
11
