7
straight gage (B), and tighten the screws securely.
After the outfeed table has been set at the correct height, it should
not be changed except for special operations.
1
If the outfeed table is too high, the result will be as shown in Fig.
11. The finished surface will be curved.
If the outfeed table is too low, the condition will be as illustraed in
Fig. 12. The work will be gouged at the end of the cut.
As a final check of the outfeed table adjustment, run a piece of
wood slowly over the knives for 6 to 8 inches should rest firmly on
both tables as shown Fig. 13 with no open space under the finished
cut.
Fig.10
Fig. 11
Fig.12
Fig. 13
