104
English
3D Audio [3D]
With this option you can adjust the intensity of the virtualizer and the virtual Dolby Atmos
®
effect to your personal taste.
Starting from default setting Normal [NOR] you can increase the effect High [HIG] or decrease the effect Low [LOW].
To adjust the setting, please to as follows:
1
To enter the menu, press the "M" button.
2
Use the
" "
or " " button to navigate to the menu System Setup [SYS] and confirm with the "OK" button.
3
Use the
" "
or " " button to select the menu item 3D Audio [3D] and confirm with the "OK" button.
4
Select the desired intensity using the "+" resp. the "–" key.
5
Confirm and exit the menu item by pressing the "M" button.
Language [LAN]
With this option you can change the On-Screen menu (OSD) language from German to English and backwards.
To change the language please proceed as follows:
1
To enter the menu, press the "M" button.
2
Use the
" "
or " " button to navigate to the menu System Setup [SYS] and confirm with the "OK" button.
3
Use the
" "
or " " button to select the menu item Language [LAN] and confirm with the "OK" button.
2
Use the "+" resp. the "–" key to select the desired volume.
3
Confirm and exit the menu item by pressing the "M" button.
Factory Reset [RES]
With this function you can reset the Smart Amp 5.1 to its factory settings. In case the Amp 5.1 has a mailfunction or does not connect to a
network anymore, please perform such a reset and repeat the installation process before you contact the customer support.
Caution:
ALL settings you have made including IR codes, the WiFi connection and paired mobile devices and speakers will be deleted.
To perform the reset using the remote control of the Amp 5.1 please proceed as follows:
1
Power up your Amp 5.1 using the Power" " " key on the remote.
2
To enter the menu, press the "M" button until the display shows [SPS] and the Main Menu is entered.
3
Use the
" "
or " " button to navigate to the menu System Setup [SYS] and confirm with the "OK" button.
4
Select the function Factory Reset [RES] and confirm with the "OK" button. The display shows [YES], the OSD indicates "Reset All".
5
To cancel the reset procedure, press the "M" button. The display shows [RES] again. Press this key additional two times to exit the menu.
