124
English
Problem
Possible cause
Solution
Playback of a (mobile)
device starts automati-
cally when the Amp 5.1
is switched on.
1. The automatic playback function AutoPlay [APL]
is activated.
1. If this function is unwanted, set AutoPlay [APL] to OFF.
Pairing of Smart (wire-
less) speakers or a Smart
subwoofer fails.
1. The slave speaker was not disconnected or was
not disconnected from the mains long enough before
pairing.
1. Disconnect the slave speaker to be paired for
at least 30 seconds from the mains.
2. The slave speaker was in standby mode
during the pairing.
2. After turning on the power switch of the slave speaker resp.
connecting it to the mains, power it up by the remote control.
3. The slave was connected to the mains before
the pairing process was initialised on the Amp 5.1
(master device).
3. Always start the pairing process at the Amp 5.1 before connec-
ting the (slave) speaker to the mains.
4. The distance between (slave) speaker and Amp 5.1
(master device) is too high.
4.1 Increase the transmission power [TXP] according to this manual.
4.2 Reduce the distance between Amp 5.1 and (slave) speaker.
The maximum distance is approx. 10 m in the same room.
Two Smart (wireless)
speakers play the same
channel.
1. Two (slave) speakers were assigned to the
same channel during the pairing process.
1. First use the test tone to check which (slave) speaker is playing
the wrong channel. Reconnect this speaker as described in the
chapter Speaker Config [SPC] / Speaker Mapping [SPM] and select
the correct channel.
The Amp 5.1 does
not change inputs
automatically.
1. The source device on the coaxial resp. optical
digital input has not been set to standby mode
or the source device does not switch off its
S/PDIF transmitter in standby mode.
1. In order to switch from the coaxial or optical digital input,
the source device must be switched off at its mains switch
resp. mus be disconnected from the mains in any other way.
2. The signal at the analoque input [AUX] is too
low.
2. Increase the output level (volume) on your analoque
source device.
