90
English
1. Speaker Setup [SPS]
The first item in the main menu is the Speaker Setup. Here you can make sound-relevant settings relating to the connected speakers.
This Speaker Setup includes the menu items
•Channel Level [CHL]
•Distance [DST]
•Crossover [XOV]
•Compression [DRC]
•Voice Clarity [VOI]
•Equalization [EQ]
•Sub Phase [PHA]
•Sub Stereo [SSM]
•Room Height [RHE]
•Device Heights [DHE]
Channel Level [CHL]
At the Channel Level menu you can adjust the volume level of each individual channel in 1dB (1 Decibel) steps between -10dB and +10dB,
where 0dB is the factory setting. For an easier relative volume adjustment between the different speakers, the unit is equipped with a test tone
generator.
Caution:
Before activating the test tone generator, please set the main volume to a level between 20 and 30. The test tone generator is de-
pending on the main volume level and cannot be increased or decreased within the menu.
For adjusting the relative volume of the different speakers connected, please follow below instructions:
1
Press the menu button "M" on the remote to enter the menu.
2
Confirm the first menu item Speaker Setup [SPS] by pressing the "OK" button.
3
Confirm the menu item Channel Level [CHL] by pressing the "OK" button.
4
As first item Test Tone [TON] is selected automatically. Press "OK" if you want to activate the Test Tone generator.
5
Select [ON] to activate the test tone generator using the "+" key, select [OFF] to disable it using the "–" key.
6
If activated, the front left speaker [FL] generates a pink noise signal. Press "M" and then the Down key "
"
, or directly the Down key "
"
to select this left front speaker [FL] from the speaker list.
7
Use the "+" resp. the "-" button to change the volume level. Go back to the speaker selection list by pressing"OK".