3
91
English
8
To select a different speaker, use the "+" resp. the "–" key.
9
The speaker selected in the list of speakers plays back the test tone. At your listening position, all speakers should have approximately the
same volume level.
10
Only speakers that have been activated in the Output Setting [OPS] / Speaker Config [SPC] menu are selectable. Speakers that have been
deactivated (displayindication [NO]) can not be selected and are grayed out.
11
It is difficult to find the correct volume level for a subwoofer, because of the different frequency band. Therefore, adjust the Subwoofer
value to your preferred level.
12
To exit the menu item, press the "M" button. The test tone generator will be deactivated automatically.
Speaker Distance [DST]
An adjustment of the distance between the speakers and listening position is needed for a perfect spatial effect, especially in case of mul-
tichannel input signals. Measure and enter the distance between the speakers and your listening position. The distance is adjustable between
0.0m and 9.9m, in steps of 0.1m, where 3.0m is the factory setting.
To adjust the distance please do as follows:
1
To enter the menu, press the "M" button.
2
Enter the first menu item Speaker Setup [SPS] by pressing "OK".
3
Select the menu item Distance [DST] using the
" "
or " " button and confirm with the "OK" button.
4
Select the speaker that you want to adjust the distance of by using the " " or " " button and press "OK".
Only speakers that have been activated in the Output Setting [OPS] / Speaker Config [SPC] menu are selectable. Speakers that have been
deactivated (displayindication [NO]) can not be selected and are grayed out.
5
You can adjust the distance by using the "+" and "–" buttons. To go back to the speaker list press the "OK" button.
6
Press the "M" button to exit this menu item.
Crossover [XOV]
With this menu item you can set the crossover frequency between a small or bookshelf speaker (Speakerconfiguration [SPC] = Small) and a
connected subwoofer. This function is only available if at least one of the connected speakers ist set as Small and if a subwoofer is activated,
otherwise this function is grayed out. In case of using Canton Smart speakers (Speakerconfiguration [SPC] = Smart) the adjustment of the
crossover frequency will be done automatically. All speakers that are set as Large (Speakerconfiguration [SPC] = Large) will receive the full
audio signal without any filtering. Multiple crossover frequencies are available between 50Hz and 200Hz. In general: The smaller a speaker,
the higher the crossover frequency.