3
93
English
[OFF] = Function is deactivated
5
Press the "M" button to exit this menu item.
Equalization [EQ]
In this menu you can adjust the frequency response of the loudspeakers that are connected to the Smart Amp 5.1 to match the room conditi-
on. You can choose between 3 EQ-settings for each speaker resp. each pair of speakers. A free position in the room is the factory setting.
To change the equalizer settings for a specific speaker or pair of speakers please do the following:
1
To enter the menu, press the "M" button.
2
Enter the first menu item Speaker Setup [SPS] by pressing "OK".
3
Select the menu item Equalization [EQ] using the
" "
or " " button and confirm with the "OK" button.
4
Select the desired speaker by using the " " and " " button and confirm your selection by pressing "OK".
5
Choose between the 3 following settings:
•EQ1 for free positioning in the room.
•EQ2 for positioning close to a rear or side wall.
•EQ3 for positioning in a corner of the room.
6
Press the "M" button to go back to the selection list and repeat the process for the rest of speakers.
7
Press the "M" button to exit this menu item.
Sub Phase [PHA]
Use this function Sub Phase to change the phase of a connected subwoofer between 0 degree (factory setting) and 180 degree (phase
inverted) relative to the other speakers. Try a phase shift of 180 degree in case the bass level at the selected rossover frequency in the menu
Crossover [XOV] seems to be much too low or completely off. This function works for both, wirelessly and wired subwoofers. This function is
only available if a subwoofer (Smart or Analog) has been selected in the menu Speakerconfiguration [SPC].
To set the subwoofer’s phase to 180 degree resp. back to 0 degree, please do the following:
1
To enter the menu, press the "M" button.
2
Use the
" "
or " " button to navigate into the menu Speaker Setup [SPS] and confirm with the "OK" button.
3
Use the
" "
or " " button select the menu item Sub Phase [PHA] and confirm with the "OK" button..
4
Change the setting using the "+" or "-" key between 0 degree [0] and 180 degree [180] and confirm with the "OK" button.
5
To exit the menu, press the Menu button "M".
Note:
This parameter is only available when a wireless subwoofer is connected to the amplifier or if Sub Out is set to ON.
