3
27
English
Note:
If you press this key on the remote control while the Sounddeck 100 is in normal mode, the system switches directly to the HD1
(BDP) input.
6
Press the desired key on the remote control. If the infrared code has been successfully stored by the system,
[OK]
is shown briefly in
the display resp. "Success" on the screen, followed by the next input.
7
If the code could not be learned,
[FAI]
appears briefly on the display resp. FAIL appears on the screen to indicate that no code has
been stored. In this case the system jumps back into the IR Menu to the item Discrete Input Learn [DIL]. Please increase or decrease
the distance between the Sounddeck 100 and the TV-/Universal remote and repeat the process. Alternatively you can try to press the
buttons of the TV-/universal remote longer or less long.
8
If you do not want to assign a button to input HD1, you can select the next input (in this case HD2) by pressing the " " button.
The " " button takes you to the previous input.
9
If you do not press any button on the TV remote control within 15 seconds, the system returns to the IR Menu.
10
The BT input is the last entry in the list. By pressing the " " key again, the system jumps back to the IR menu.
Note:
Due to the variety of infrared codes it is not possible to guarantee that every IR remote control signal can be learned by the
Sounddeck 100. Signals from radio frequency (RF) remote controls cannot be learned, generally!
IR Clear [CLR]
With this function you can delete all IR codes stored on the Sounddeck 100 in case you do not want the Sounddeck to react to the IR
codes of your TV / third party remote control any longer.
To delete the IR commands learned by the Sounddeck 100, please do the following:
1
To enter the Menu, press the "
M
"
button.
2
Use the
" "
or " "
button
to navigate into the menu
System Setup [SYS]
and confirm with the "
OK
"
button
.
3
Use the
" "
or " "
button
to select the
IR Menu [IRM]
and confirm with the "
OK
"
button
.
4
Choose the function
IR Clear [CLR]
by using
the
" "
or " "
buttons
and press
OK
. The OSD shows the IR Clear menu and "No" is
selected. The display indicates [NO].
5
To cancel the operation, press the "M" key or press "OK".
6
To delete stored codes please use the " " button to select "Reset All", the display shows [YES]. Please press "OK" to delete the
codes.
7
The screen will display "Please Wait" for 3 seconds. The system will then return to the IR menu. The display confirmes the deletion by
showing [CLR].
