32
English
Sub Out [SUB]
The Sounddeck 100 has a build-in subwoofer. Therefore the fuction Sub Output [SUB] is deactivated ([OFF]) by default. To expand the
frequency range and to enhance low level frequency reproduction the Sounddeck 100 can be extended with an external subwoofer. You can
integrate an additional subwoofer in the following ways:
• Connecting an active subwoofer using a RCA cable: If you set the function "Sub Out" to wired [WRD], you can connect your active
subwoofer to the SUB OUT on the rear of the Sounddeck 100 using a cinch-RCA-cable. In this case the internal subwoofer of the
Sounddeck will automatically be limitied to 80 Hz and frequencies below 80 Hz will be routed to the external subwoofer.
• Pairing a wireless subwoofer from Canton Smart Series: The Sounddeck 100 has a build-in wireless transmitter that can stream audio and
control commands wirelessly from the Sounddeck to paired wireless speakers and/or subwoofers from the Canton Smart Series within
your room. In case you have paired a wireless subwoofer in the menu "Wireless Setup [WIS] / Wireless Pairing [WSP], the option
"Wireless [WLS]" will additionaly be available in the "Sub Output" menu. This means, that the connected subwoofer gets the audio as
well as the control commands (state, volume, etc.) wirelessly.
• Connecting a wireless subwoofer from the Canton Smart Series using a signal cable: As an alternative to the wireless audio transmission,
you can connect your subwoofer with a signal cable, so that the audio data is transmitted over the RCA cable and the control commands
are transmitted wirelessly. This way, the Smart subwoofer can be used like a "normal" subwoofer, but will still be controlled and adjusted
by the Sounddeck 100. To do so, please set the option to "Wireless [WLS]" after you have successfully paired a Smart subwoofer
according to chapter "Wireless Pairing [WSP].
To enable the subwoofer output [WRD] or [WLS] resp. disable the output [OFF], please do the following:
1
To enter the menu, press the "
M
"
button.
2
Use the " " or " "
button
to navigate into the menu
System Setup [SYS]
and confirm with the "
OK
"
button
.
3
Select the menu item
Sub Out [SUB] using
the " " or " " buttons
and confirm with the "
OK
"
button
.
4
Change the setting Wired [WRD] or Off [OFF], in case Wireless [WLS], using the
+/-
keys and confirm your selection with "OK".
5
To leave the menu, press the Menu button "M".
Sub Phase [PHA]
Use the function
Sub Phase
to change the phasing of a connected (Smart) subwoofer between 0 degree and 180 degree (phase inverted) re-
lative to the Sounddeck 100. Try a phasing of 180 degree in case the bass level at the selected crossover frequency (80 Hz) seems to be much
too low or completely off. Dependend on the position of the Sounddeck 100 and the subwoofer, phase cancellation may occur around the
crossover frequency. In most cases these phase cancellations can be avoided with a 180 degree shifted (inverted) subwoofer audio signal. This
function works for both, wirelessly and wired subwoofers.
