3
47
English
Problem
Possible cause
Solution
The Sounddeck 100
does not turn on
automatically.
1. The standby function is factory set to Network
[NSB]. The system must be turned on manually.
1. In order to automacially turn on, the standby function
must be switched to Auto [AUT].
2. The device has been switched off via the
“ON / Standby” button of the remote control
or the “Power” button of the TV remote
control (when using the IR learning function).
2.1 Switch on the Sounddeck 100 via the “ON / Standby”
button of the remote control and wait until it automatically
switches to the standby mode, next time.
2.2 Delete the “Power” button of your TV remote from the
Sounddeck 100 to prevent it from switching off together with
your TV.
3. The signal from the source at the analogue
input [AUX] is too low.
3. Increase the output level (volume) on your analogue
source device.
The Sounddeck 100
switches off
unintentionally.
1. The standby function was set to ECO, AUT or
NSB.
1. Select the standby function Manual [MAN] if the Sound-
deck 100 is meant to stay on, even without an input signal.
2. The infrared command for Standby has been
learned incorrectly.
2. Learn the infrared command for On (turn on) resp. Stand-
by (turn off) again.
The Sounddeck100
does not turn off
automatically.
1. The standby function is set to Manual [MAN].
1. Activate the standby function ECO, AUT, or NSB.
2. The standby function Auto [AUT] is activated
and the source device also transmits a carrier
signal in standby mode (optical or coaxial digital
input, only).
2. Switch off the source device at its mains switch or dis-
connect it from the mains in any other way.
