3
51
English
Problem
Possible cause
Solution
The Sounddeck 100
unintentionally chan-
ges the input.
1. This can happen if the function Input Select
[SEL] is set to [AUT] and the currently selected
analoque input [AUX] has a long break in the
playback (>10 seconds) and a signal is present at
another input or the source device is turned on
at the optical and coaxial input.
1.1 Make sure that no signal is present at any other input
during playback at the analoque input [AUX] or
that a device is switched on at the optical and coaxial
digital input.
1.2 Deactivate the function Input Select [SEL].
2. This can happen when your (mobile) device
plays system sounds, such as typing on the
keyboard.
2.1 Disable these system sounds on your (mobile) device.
2.2 Deactivate the function Input Select [SEL] resp. BT Select
[BTS].
Paired wireless
speakers do not turn
on together with the
Sounddeck 100.
1 The (slave) speakers are not paired to the
Sounddeck 100, till now.
1. Pair all slave speakers according to chapter Wireless Pairing
[WSP].
2. The parameter Standby [STB] is set to ECO
[ECO].
2. If the parameter STB is set to [ECO], each speaker must be
switched on separately with the remote control. If you want
to switch all speakers on together, set the parameter to NSB,
MAN or AUT.
An input cannot be
selected via the Input
buttons " " or " ".
1. The input was deactivated in the Input Config
[INP] menu (---).
1. Activate the input according to chapter Input Config [INP].
The volume is
limited to a value
less than 70.
1. In the Max Volume [VOL] menu, a maximum
volume less than 70 was selected.
1. Increase the value according to chapter Max. Volume
[VOL].
