3
73
English
CLR (IR Clear function)
To erase the infrared commands learned by the speaker from the TV remote control, please do the following:
1
Select the SYS menu as described in the chapter SYS (System Setup) and select the IRM function using
the navigation buttons “ ” and “ ” and press OK.
2
Use the navigation buttons “ ” and “ ” to select the CLR function and then press OK.
3
Now press the “+” button� CLR will appear in the display for approx� 5 seconds�
STB (Stand By Mode)
This function determines how the system is switched on or off, possibly depending on an incoming audio signal� If ECO is selected, the system
will switch to standby mode after one hour without a signal and must be switched on again manually by remote control� If the value AUT is
selected, the system switches on automatically when an input signal is detected, it switches into standy mode after 1 minute for digital inputs
(opt, coax, BT) and after 15 minutes for analog inputs (XLR and Analogue Line as well as USB) without a detected input signal� With the MAN
setting, the system will remain permanently switched on even without an input signal and must be switched on or off via the remote control�
If the NSB (network standby) option is selected, the system will switch to the standby state after one hour without an input signal, as with
the ECO setting, and must be switched on again manually� The difference is that in the ECO setting, the speakers connected via radio are
switched off but not switched on again with the master� All speakers must be activated individually� With the NSB and MAN and AUT settings,
however, all speakers connected via radio are switched on again when the master is switched on�
Note:
When the STB function is set to AUT, and the speaker is set to standby mode manually using the remote control, it is not possible for
the speaker to power up automatically�
Note:
To avoid inadvertent switching on due to noise on the analogue inputs, the threshold value was set quite high� To ensure that the
system switches on safely, raise the volume of your source device to the highest possible value, but no more than 2VRMS�
To change the Stand By Mode, proceed as follows:
1
Select the SYS menu as described in the chapter SYS (System Setup) and select the STB function using the navigation buttons “ ” and “ ”.
2
Use the “+/–” buttons to set the desired value�
Summary of Contents for Smart Vento 9
Page 38: ...3 39 Deutsch 3 Klicken Sie nun auf Ausgabe und w hlen Sie den Canton Lautsprecher aus...
Page 52: ...31 English S m a r t V e n t o 9 S m a r t V e n t o 3...
Page 89: ...3 91 English 3 Now click on Output and select the Canton speaker...
Page 105: ...3 71 English Notes 180129_Manual_Canton_DM60_D_E_RZ_0316 indd 71 22 03 18 11 54...
