11
Fasten
Height
adjustment
ring
Stand cover
Four
screws
Stand
Tighten
Loosen
Loosen
Annular groove
Thumb screw
Mounting hole
ASSEMBLY OF CROSS STAND & COLUMN
UNIT
1. Undo the four sets of screws, washers and spring washers that are fitted to the centre of the
stand, then attach the extension pole to the stand using these screws. (Fig. 1)
2. Loosen the height adjustment ring, lift the internal pole to the max height and prevent the
internal pole from slipping into the extension pole, then unscrew and remove the height
adjustment ring. (Fig. 2)
3. To attach the stand cover, slide the stand cover down the extension pole. (Fig. 3)
4. Reattach the height adjustment ring. (Fig. 4)
5. Loosen the height adjustment ring on the extension pole and adjust the internal pole to the
desired height. (Note: If you cannot see the internal pole it may have slipped inside the
extension pole. You can pull it out from the extension pole.) (Fig. 5)
6. To attach the head unit to the internal pole, loosen the thumb screw on the bottom of the
head unit. Place the head unit on the internal pole and tighten the thumb screw until it is in
line with the groove on the internal pole. (Fig. 6)
