Canvas A208005504, Assembly Instructions Manual

To obtain the best performance from your fire table, you must perform the following 
storage and maintenance activities on a regular basis: 

Allow at least 35 minutes for the fire table to cool down after 

use, before disconnecting and removing the gas cylinder.  

Store the gas cylinder in a dry, well-ventilated and 

sheltered area protected from inclement weather and dust, 
out of the reach of children, and not in a building, garage or 
any other closed area.  

The fire table may be stored indoors only if the cylinder is 

disconnected and removed.   

Keep the fireplace area clear and free from combustible materials, 

gasoline and other flammable vapours and liquids. 

Installation and repair should be done by a qualified service person. The fire table 

should be inspected before use and at least annually by a qualified service person. 
More frequent cleaning may be required as necessary. It is imperative that the control 
compartment, burner, and circulating air passageways of the fire table be kept clean.

If you disassemble the burner when cleaning the fire table, please reassemble it 

according to the picture on the right to make sure the burner induction tunnel is on 
and exactly covers the orifice base. It is imperative that the control compartment, 
burner, and circulating air passageways of the fire table be kept clean. It is recommended 
not to disassemble the burner. 

Permanent installation and repair should be done by a qualified service person. The 

fire table should be inspected annually by a qualified service person. 

STORAGE AND MAINTENANCE

TROUBLESHOOTING

PROBLEM OBSERVED

POSSIBLE CAUSE

CORRECTIVE MEASURES

Gas odour 

G as l

Low gas pressure 

Clogged or dirty burner 

ports 

Blocked orifice 

Spent battery

Incorrect gas supply or 

pressure 

Blocked orifice 

Clogged or dirty burner ports

eak

.

.

Check gas supply pressure.

page 2

Delayed ignition

C lean burner ports—see manual

section.

C heck orifice opening.

Replace battery.

Check gas supply pressure.

Incorrect burner flame

C heck and clean orifice opening.

C lean burner ports.

MODEL NO. 088-2208-8 | PRODUCT NO. A208005504