5
MODEL N0. 085-1569-0
(
)
IMPROTANT SAFETY INFORMATION AND PRECAUTIONS
The minimum distance between the brazier and the
cylinder is 30" (76.2 cm).
WARNING: The cylinder poses a tripping hazard.
Open the door and inspect the hose assembly and burner
prior to each use. If there is evidence of excessive abrasion
or wear or if the hose or burner is damaged, it must be
replaced by an appropriate part from the manufacturer.
Inspect the gas connections of the appliance prior to each
use. Do not operate the unit if there is a gas leak. Have the
appliance inspected annually by a qualified service person.
The pressure regulator and hose assembly provided with the appliance must be used. The replace-
ment part must be the same as the part specified by manufacturer.
For instructions on how to connect the LP-Gas tank and check for leaks, please refer to the “Gas
Connection” on page 9 and “Leak Test” on page 9.
Children and adults should be alerted to the hazards of high surface temperatures and should stay
away to avoid burns and prevent clothing ignition.
Young children and pets should be carefully supervised when they are in the area of the appliance.
Any guard or other protective device removed for servicing the appliance must be replaced prior
to operation.
Clothing or other flammable materials should not be hung from the appliance or placed on or near
the appliance.
Do not use this appliance if any part has been under water. Immediately call a service technician to
inspect the appliance and to replace any part of the control system which has been under water.
LP-Gas supply cylinder to be used must be constructed and marked in accordance with the specifi-
cations for LP-Gas cylinders of the U.S. Department of Transportation (DOT).
The cylinder supplies system must be arranged for vapour withdrawal and the cylinder must include
a collar to protect the cylinder valve.
Use only 20 lb (9 kg) LP-Gas cylinders.
Do not burn wood or any other materials in this appliance.
The appliance must be isolated from the gas supply piping system by closing its individual manual
shutoff valve during any pressure testing of the gas supply piping system at test pressure equal to or
less than 1/2 PSI (3.5 kPa).
Other cylinders may be acceptable for use with the appliance provided they are compatible with
the appliance retention means and accompanied by illustration(s) depicting the cylinder mounted on
the appliance using the cylinder retention means and the point of contact between the cylinder and
the retention means.
Properly place the hose out of pathways where people may trip over it or
in areas where they may be subject to accidental damage.
The burner must be replaced prior to the appliance being put into
operation if it is clear that the burner is damaged. The replacement
burner must be the same as the part specified by the manufacturer.
To clean the appliance, including the burner, please refer to “Storage and
Maintenance” on page 1 .
30"
(76.2 cm)
18" (46 cm)
12 1/2" (32 cm)
