11
MODEL NO. 085-1557-8
L-FT1047PST-F
LIGHTING THE BURNERS
OPERATION & LEAK TEST
Do not use an open flame to check for leaks.
Do not smoke during testing.
Do not test indoors.
A leak test must be performed whenever the gas cylinder is replaced.
!!!WARNING!!!
NOTE:
While in use, the burner flame should be mainly blue in appearance with a small
amount of yellow. The flame can be identified by the following figure.
1. Make sure the control knob is in the “OFF” position.
2. Make sure the gas cylinder is correctly and securely connected to the pressure regulator,
without over-tightening.
3. Turn on the gas cylinder valve. Apply 50% soap and 50% water solution to the gas hose
and connections between the control knob and gas cylinder.
4. If something is leaking, you will see bubbles form. In case of leaks, turn off the gas supply,
undo the leaking connection, re-connect it and try again. If the leak persists, consult Customer
Service Centre for assistance (1-888-670-6684).
5. If the connection does not leak, continue to the next step.
1. Make sure control valve is OFF.
2. Turn on gas tank valve.
3. Press in and turn control valve knob counter-clockwise to
LOW to light. See the figure to the right.
4. If burner is lit, continue pressing in the control valve knob
for a minute to heat the thermocouple.
5. When control valve knob is released, the burner should be
lit. If not, turn control valve knob clockwise to OFF. Wait for 5
minutes then start with step 3 above.
6. Press in and turn control valve knob to desired heat output,
LOW ~ HIGH.
LEAK TEST
OFF
HIGH
MAX
BAS
ARRET
LOW
Warning: Lighting the fire table improperly could lead to an unsafe condition.
7. Press in and turn the control valve knob clockwise to OFF to shut down fire table..
Close the gas cylinder valve when the fire table is not in use.
(
CAUTION:
Do not kink flexible gas hose. If it is kinked, a gas leak could occur.)
YELLOW TIPS
HIGH
LOW
LOW
BLUE
BLUE
Summary of Contents for Dashley 085-1557-8
Page 6: ...6 EXPANDED VIEW H ...
