background image

 

 

Canvys-VT15_17_19_VGAonly_EN_Manual.doc  

Heike Rettschlag 

 

2  of 12  

A. Federal Communications Commission (FCC) Statement 

This Equipment has been tested and found to comply with the limits for a class B digital 
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment generates 
uses and can radiate radio frequency energy and if not installed and used in accordance with 
the instructions, may cause harmful interference to radio communications. However, there is 
no guarantee that interference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which can be determined by turning 
the equipment off and on, the user is encouraged to try to correct the interference by one or 
more of the following measures:   
- Reorient or relocate the receiving antenna. 
- Increase the separation between the equipment and receiver. 
- Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 
- Consult the dealer or an experienced radio/TV technician for help. 
 
Warning: 
A shielded-type power cord is required in order meet FCC emission limits and also to prevent 
interference to the nearby radio and television reception. It is essential that only the supplied 
power cord be used. 
Use only shielded cables to connect I/O devices to this equipment. 
You are cautioned that changes or modifications not expressly approved by the party 
responsible for compliance could void your authority to operate the equipment. 
 

 

B. IMPORTANT SAFEGUARDS  

Warning: 

1.

 

Read all of these instructions. 

2.

 

Save these instructions for later use. 

3.

 

Unplug this monitor from the wall outlet before cleaning. DO NOT use liquid cleaners or 
aerosol cleaners. Use a damp cloth for cleaning. 

4.

 

DO NOT use attachments not recommended by the monitor manufacturer as they may 
cause hazards. 

5.

 

DO NOT use this monitor near water. For example near a bathtub, washbowl, kitchen 
sink, or laundry tub, in a wet basement or near a swimming pool, etc... 

6.

 

DO NOT place this monitor on an unstable cart, stand, or table. The monitor may fall, 
causing serious injury to a  child or  adult and serious damage to the appliance. Use  it 
with a cart or stand  only recommended by the manufacturer or sold with monitor. Wall 
or shelf mounting should follow the manufacturer's instructions, and should use a 
mounting kit approved by the manufacturer.   

7.

 

Slots and openings in the cabinet and the back or bottom are provided for  ventilation 
and to insure reliable operation of the television receiver and to protect it from 
overheating, these openings must  NOT be blocked or covered. The openings  should 
NEVER be blocked by placing the monitor on a bed, sofa, rug or other similar surface. 
This monitor should  NEVER be placed near or over a radiator or heat register. This 
monitor should  NOT be placed in built-in installation such as a bookcase unless proper 
ventilation is provided.   

Summary of Contents for LC-VT1503 Series













Reviews: