Fig. 7.1
2
Fig. 7.1
3
Fig. 7.1
4
8. Camera installation
Install the camera on a stable flat surface near the power supply 220V or on a pre-attached
mounting bracket at the desired angle.
* Try to choose a place where the camera will not interfere with anything, and will also be
protected from moisture.
9. Motion sensor installation (Fig. 1.2),
for CNSS-KA
1
W model only
Install it only where it can monitor the zone necessary for triggering.
There should be no interference between the sensor and the operating zone at a distance of
1 meter from the sensor.
* For the correct operation of two or more sensors in the same room, install them so that the
coverage area of the sensors does not overlap, otherwise false alarms may occur. In
addition, do not install your sensor against reflective surfaces (windows, mirrors, glass
doors).
* Please note that it is not necessary to install the sensor at the maximum height, since for
the maximum detection range it will be necessary to extend the sensor antenna. Avoid
moisture entering the sensor.
