EN
Depending of location, it will send GPS
*
or LBS coordinates.
Under the open sky, while the GPS satellites “see” the watch,
coordinates are much more accurate. If the watch sends GPS
coordinates, you can see the following icon on the screen .
Inside of the buildings it will switch to LBS mode automatically.
LBS positioning works by GSM towers coordinates, so the
accuracy of positioning depends on quantity of the GSM towers
of your telecom operator are placed at the area.
Open the map in APP and select the registered device to see
real-time position of the watch Setup safe zone, check the
tracking history, initiate chat, refresh actual coordinates (force
positioning), check the type of signal, etc…
*
Location definition cause high power consumption. We suggest
to set up normal or battery save mode of positioning settings in
APP. Use precise or forced mode for short time for fast getting
real-time coordinates. Anyway we’re using special algorithms
to safe the battery life, so please be patient if it doesn’t send
new coordinates immediately after being in one place without
moving for a long time.
9. sos
To initiate SOS call, press and hold the SOS key. Outgoing call
to SOS number will be initiated automatically.
Set up to 3 SOS phone numbers in the APP. After pressing
the key, it will call by circle to these 3 numbers 2 times until
somebody of abonents will not pick up the phone.
EN
10. hiDDen fUnctions
Call back.
From the APP initiate outgoing call from the watch to
specified phone number. Microphone and dynamic will be
activated normally. The information about outgoing call will
be displayed on the watch screen during the call.
Hidden call back.
From the APP initiate hidden outgoing call from the watch
to host phone number (called Main Phone in APP). The
information about outgoing call will be displayed on the
watch screen for 3 second and then disappear. Microphone
will work, but the speaker of the watch will be deactivated.
Remote photo.
From the APP request remote photo. The APP will send the
command, the watch will activate camera, make the picture
and send it back to the APP Chat.
Find the watch.
Initiate this function in APP. The watch will get signal and
will start alarm loudly. Find the watch and switch off the
alarm.
Alarms.
You may set up to 3 alarms trough the APP.
Silent mode.
In APP set the interval when the watch will be work in silent
mode. Only main screen with current time, call back &
hidden call back, flashlight using key buttons function will be
granted. Also watch will show incoming chat text messages
and notification about incoming chat voice messages. The
