WSD10TGII
User Manual
WA0375E_WSD10TGII_User Manual_R08
V4.6
CAPETTI ELETTRONICA s.r.l. - Strada Stratta 57
10090 CASTIGLIONE TORINESE - TORINO - ITALY
VAT 04837130014 - Phone 011.981.98.11 - Fax 011.981.98.210
e-mail info@capetti.it - web www.capetti.it
5/9
6.
Enrolling the device.
Not necessary if performed in factory before delivery.
Enroll the device to the network referring to the “
WineCap System - User Manual R29
”. In case the device is already enrolled but in
STANDBY
status, a
TEST
command must be issued (
refer to
).
7.
Installation procedure.
After installing the
basestation
in appropriate place in charge, (
refer to “
WineCap System - User Manual R29
), be sure that the device is
enrolled to the
basestation
and activated.
Head for the environment to be monitored. On the way, to check the quality of the radio coverage, use the "
Field Measurer
"
function.
This function is activated issuing the
TEST
(
)command: position the
Picture 3 - WineCapKey positioning
AMBER
"
Field Measurer
" function lasts enabled for two minutes.
To issue commands to the device, place the
where indicated.
is detected, the led periodically emits
AMBER
flashes with a 2 seconds cadence.
For each flash, a different command is associated; to confirm the command the
must be removed from the sensible
area immediately after the number of flashes corresponding at the desired command. The
TEST
corresponds to the second pulse
and activate the "
Field
Measurer
" function.
The device will give back the radio signal quality through led flashes:
WIRELESS MODE STATUS
Table
Flash count - Wireless mode
Status/Radio signal quality
5 green flashes
Excellent
4 green flashes
Good
3 green flashes
Fair
2 amber flashes
Sufficient
1 red flash
Insufficient
1 red flash 2” long
OUT OF RANGE
Network searching
2 red flashes 2” long
STANDBY
Short-long-short red
flashes series
FACTORY RESET
Device not enrolled
Optimize reception selecting the best position: small movements can help.
If the signal is absent or insufficient at the install point, a
refer to “
itself must be located in a position where the signal level is at least sufficient.
The network will reconfigure itself automatically; the signal will be good again when the device synchronizes with the
The link will not be reconfigured until completely lost by the device. Because of this, in some cases it could be necessary to force
the operation. In such cases, put the device in
STANDBY
mode, then run the
TEST
again (
refer to “
WineCap System - User Manual R29
NOTE
: The display equipped
datalogger
) is recommended, to verify the signal quality during devices installation.
Picture 6 - Status table - Radio signal quality
