WSD10TII
User Manual
PAGE 2/11
WA0425_WSD10TII_User Manual_R02 V6.0
www.
capetti
.it
1.
Disclaimer.
•
Specifications are subject to change without notice and should not be interpreted as any commitment on the part of Capetti Elettronica
S.r.l.
•
Capetti Elettronica S.r.l. assumes no responsibility for any errors that may appear in this document. In no case Capetti Elettronica S.r.l.
will be liable for incidental or consequential damages resulting from the use of this document or the systems described in this
document.
•
All Contents published or distributed by Capetti Elettronica S.r.l. are made available for general information purposes.
•
It is not permitted to publish or use, in whole or in part, such contents for commercial purposes without the explicit written consent
of Capetti Elettronica S.r.l.
•
The reproduction, duplication, modification, sale or resale of this material or part of it is not permitted without the explicit written
consent of Capetti Elettronica S.r.l.
2.
General warnings.
•
The following information must be read and understood before proceeding with the installation, commissioning and maintenance of
the devices described in this document.
•
ATTENTION! Any omission or failure to follow these instructions scrupulously can cause danger.
•
ATTENTION! Explosion hazard. In case of batteries substitution, make sure that the type is compatible and complies with the
specifications indicated by the manufacturer.
•
In case of batteries substitution, DO NOT disconnect the flat cable which connect the electronic boards without removing batteries
before.
•
ALWAYS substitute all the batteries, also in case of one single battery exhausted.
•
If the device is powered by a fixed network, make sure you have disconnected the power supply before carrying out any type of
intervention. Failure to comply with this indication can cause damage to people and/or property.
•
Follow the manufacturer's suggested warm-up time (
time required to obtain a reliable measurement
) of the transducer.
•
Follow the manufacturer's suggested electric wiring of the transducer to measure (
ground shields at a single point, cable length and
section
); voltage measures on distances exceed 15/20 meters are subjected to electromagnetic disturbances. 0
÷
25mA inputs have a
superior electromagnetic compatibility (
EMC
).
•
Avoid passage in cavities with power or high voltage cables.
•
The protection and safety measures and the warranty provided by the Manufacturer with the equipment may be compromised if it’
s
used in a manner that does not comply with this user manual.
•
This equipment complies with CE regulations.
•
Modifications or tampering not expressly approved by the Manufacturer could void the user's authorization to operate the equipment.
•
This equipment must be installed by qualified personnel and in accordance with national regulations and/or related local requirements.
•
Make sure that the object is properly fixed to supports/infrastructures capable of withstanding this load. Make sure proper methods
and materials are used when fixing the equipment to a wall.
•
Only service personnel authorized by the manufacturer or personnel expressly authorized by the latter can open the container. There
are no user serviceable parts inside.
Summary of Contents for WSD10TII
Page 1: ...WSD10TII User Manual ...
