WSD10TII
User Manual
PAGE 7/11
WA0425_WSD10TII_User Manual_R02 V6.0
www.
capetti
.it
9.
Device enrolment.
Not necessary if performed in factory before delivery.
Enrol the device to the wireless network (868MHz/915MHz) referring to the
WineCap System - User Manual R30
. In case the device is already
enCH2ed but in STANDBY status, a TEST command must be issued (refer to
.
10.
Installation procedure.
After installing the gateway in appropriate place in charge, (
refer to
WineCap System - User Manual R30
”),
be sure that the device is enCH2ed
to the gateway and activated.
Head for the installation point. On the way, to check the quality of the radio coverage, use the "Field Measurer" function.
This function is activated issuing the TEST
(refer to
Picture 4 - WineCapKey positioning
and wait for two AMBER flashes, then remove the
from device. The "Field Measurer" function
lasts enabled for two minutes.
To issue commands to the device, place the
, is detected, the led periodically emits AMBER flashes with a 2 second cadence.
For each flash, a different command is associated; to confirm the command the
must be removed from the sensible area
immediately after the number of flashes corresponding at the desired command. The TEST corresponds to the second pulse and activate the
"Field Measurer" function.
The device will give back the radio signal quality through led flashes:
WIRELESS MODE STATUS Table
FLASH COUNT
–
WIRELESS MODE
STATUS/RADIO SIGNAL QUALITY
5 green flashes ACTIVE - Radio signal: Excellent
4 green flashes ACTIVE - Radio signal: Good
3 green flashes ACTIVE - Radio signal: Fair
2 amber flashes ACTIVE - Radio signal: Sufficient
1 red flash ACTIVE - Radio signal: Insufficient
1 red flash 2” long
OUT OF RANGE
Network searching
2 red flashes 2” long
STANDBY
Radio off - No Logging
Short-long-short red
flashes series
FACTORY RESET
Device not enCH2ed
–
No logging
Picture 6 - Status table
–
Wireless mode
Optimize reception selecting the best position: small movements can help.
If the signal is absent or insufficient at the install point, a
refer to
”).
itself must be in a position where the signal level is at least sufficient.
The network will reconfigure itself automatically; the signal will be good again when the device synchronizes with the
The wireless communication will not be reconfigured until completely lost by the device. Because of this, in some cases it could be necessary
to force the operation. In such cases, put the device in STANDBY mode, then run the TEST again (
refer to
NOTE: The display equipped datalogger
is recommended, to verify the signal quality during devices installation.
Summary of Contents for WSD10TII
Page 1: ...WSD10TII User Manual ...
