86
EN
CARE AND MAINTENANCE
Note
: As with all training machines with mechanical, moving components,
screws may loosen due to frequent use. We therefore recommend that you
check them regularly and, if necessary, retighten them with a suitable key.
Clean your training device regularly with a damp cloth to clean the surfaces
from sweat and dust.
•
When you don’t use the exercise bike for a long time, please take out the
console battery to avoid running out of battery.
• Often clean the exercise bike with clean cloth to keep the clean
appearance.
• The safety level of the equipment only can be maintained if it is regularly
examined for damage and or /wear and tear.(e.g. handle bar, pedals and
seat ...etc.).It is vital that any faulty parts are replaced and the it is not used
until completed repaired.
• Regularly check that the elements fastened with nuts and bolts are
correctly tightened.
• Remember regularly to grease moving parts.
• Special attention to the component, most of them are susceptible to wear
like brake system, foot pad etc.
• As sweat is very corrosive, do not allow it to come into contact with the
enameled or chromed parts of the equipment, particularly the computer.
Immediately wipe the equipment after using. The enameled parts can be
cleaned using a damp sponge. All aggressive or corrosive products must be
avoided.
• Storing the equipment in a clean and dry environment away from children.
Belt adjustment
The position of belt is adjusted before shipment. However, sometimes the belt
may shift off center during transportation. To adjust a slipping belt, please use
the enclosed hex wrench turn the screws at rear (both sides) of the deck to the
right by 90 degrees until no slippage occurs. Make sure the belt is not moving
while adjusting the screw.
