the hinge supports on the stove body and re-fit the door, repeating this until a tight seal is achieved. The door catch can be adjusted
by unfastening the nut on the back of it and placing washers either in front of or behind the catch itself to move it in or out.
ANNUALLY- SWEEP THE CHIMNEY
The entire length of the chimney from stove to outlet should be swept annually, or more often if
smoky fuels are used.
REFURBISHMENT
Should the stove body become scratched or dull, repaint it only with heat resistant paint supplied for the purpose
and only when the fire is completely cold. A small jar of paint is supplied with the stove.
NEW PARTS
This product has been extensively tested for safety - please don't try to modify it and always obtain
genuine
spare parts.
SPARE PARTS
1 Main casing
4 Main casing Base
6 Main casing Top
7 Flue outlet collar
8 Flue outlet blank
9 Throat plate
10 Grate frame
11 Front firebar
12 Grate
14 Door
15 Primary air slide
18 Hinge and pin
19 Ashpan
20 Window
21 Glass rope - large
22 Glass rope - small
23 Door catch assembly
24 Operating tool
25a Leg
26 Brick - rear
27 Brick - side left or right
28 Fire cement
29 Stove black paint
30 Handle-
30O - Solid Oak Handle
30B - Solid Black Handle
31 Screws and fixings pack
32 Cast Trellis
The stove is fully guaranteed for one year from the date of purchase, in addition to your statutory rights.
www.capitalfireplaces.co.uk
Distributed in Europe by:
Capital Fireplaces, Unit 12, Henlow Ind Est, Henlow Camp, Beds SG16 6DS UK
Tel: 01462-813138
4
Designed in England by Glyn Hughes Design. The SIRIUS TRADITIONAL Clean Burn Stove is registered at the UK Patent Office, and is fully protected by
Copyright © and UK Design Right, Glyn Hughes 1999/2005. Assembled by the people of Gao Zhuangzi Village, Tianjin, China from components
manufactured in the UK, USA, Japan and China. The suppliers reserve the right to change any specification without notice. CD&P Act 'right of recognition' is
invoked.
Issue:
v177 of 09/11/2010