3
Electrical Installation
Your hob must be installed by a
qualified electrician using 6 mm
2
cable
in line with all electrical and installation
requirements published by the Institute
of Electrical Engineers.
A double pole isolating switch must be
provided no further than 2 metres from
the appliance to the electrical supply.
All supply current and earth conductors
must be able to withstand an ambient
temperature of 75°C.
As the colours of the wires in the
mains lead for the appliance, may not
correspond with the coloured markings
identifying the terminals in your spur
box, proceed as follows:
1) The wire which is coloured green
and yellow must be connected to
the terminal marked E (Earth)
or coloured Green.
FUSE
DOUBLE POLE SWITCHED
FUSED SPUR OUTLET
USE A 30 AMP FUSE
ON
Fig. 1
2) The wire which is coloured blue
must be connected to the terminal
marked N (Neutral), or coloured
Black.
3) The wire which is coloured brown
must be connected to the terminal
marked L (Live), or coloured Red.
This appliance is intended to be per-
manently connected fixed wiring.
WARNING!
ELECTRICITY CAN BE
EXTREMELY DANGEROUS.
THIS APPLIANCE MUST BE
EARTHED.
Installation Requirements
Technical details
ELECTRIC HOB
Total absorbed power
6000 W
Rapid plate 180 mm
2000 W
Rapid plate 145 mm
1500 W
Normal plate 180 mm
1500 W
Normal plate 145 mm
1000 W
Voltage
230 V - Single phase
