Page 4 of 9
C155L C165R user manual.DOC
INSTALLATION
•
In order to avoid damage to persons or property, the equipment should be installed by
two persons.
•
In the event of damage to the equipment during transport, immediately inform the
supplier before proceeding to installation. The equipment must be placed in a dry, well
ventilated position.
•
The equipment must be installed on a flat, stable surface, using the adjustable feet if
necessary and following the instructions provided inside the product. In fitting the
equipment inside the unit make sure you don't squash the power cable.
•
Air inflow to and outflow from the equipment must be ensured by means of an aperture
in the skirting board and a vertical slit in the rear of the unit.
•
Minimum transverse section of aperture in skirting board and slit: 250cm2.
•
Ambient temperature has a considerable influence on energy consumption, so the
equipment should not be exposed to direct sunlight or placed by heat sources such as
radiators, heaters, cookers, etc. If necessary install insulation paneling against the sides
of the unit.
Check the climate classification on technical data plate on the inside of the equipment, on
the left hand side.
"SN" (operates at ambient temperatures between) +10° C and +32° C
"N" (operates at ambient temperatures between) +16° C and +32° C
"ST" (operates at ambient temperatures between) +16° C and +38° C
"N" (operates at ambient temperatures between) +18° C and +43° C
WARNING
It is important to ensure access to the equipment's power outlet in the wall, so that the plug
can be removed if necessary. If this isn't possible, connect the equipment to the mains via a
double pole switch with a contact opening distance of at least 3 mm in an accessible
position.
ELECTRICAL CONNECTION
Connection of the equipment to a power outlet with an earth contact is required by law. For
this reason the equipment is provided with a plug with an earth wire to fit in an outlet of the
same type. The manufacturer declines any liability for damage to persons or property due to
failure to observe this rule.
Check that the voltage indicated on the technical data plate inside the fridge on the left
hand side is the same as that of your mains supply.
Instructions for replacing internal light:
Disconnect the plug or switch off the main supply switch before changing the light. The new
lamp must be of the same wattage as the value indicated on the lamp shield (e.g. max. 15
Watt).
