Instruction manual C808C
Please keep this instruction manual for future reference
17
BEFORE INSTALLING THE HOB
- The ceramic hob must be installed by qualified personnel or technicians. Please
never conduct the installation by yourself.
- Check the work surface is square and level, and no structural parts interfere with
the space requirements.
- Ensure the work surface is made of a heat-resistant material.
- If the hob is installed above an oven, check the oven has a built-in cooling fan.
- The installation must comply with all clearance requirements and applicable
standards and regulations.
- Ensure a suitable isolating switch providing full disconnection from the mains
power supply is incorporated in the permanent wiring, mounted and positioned to
comply with the local wiring rules and regulations.
- The isolating switch must be of an approved type and provide a 3mm air gap
contact separation in all poles (or in all active [phase] conductors if the local
wiring rules allow for this variation of the requirements).
- The isolating switch must be easily accessible to the customer once the hob is
installed.
- Consult local building authorities and by-laws if in doubt regarding installation.
- Use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the
wall surfaces
AFTER INSTALLING THE HOB
- Ensure the power supply cable is not accessible through cupboard doors or
drawers.
- Ensure there is an adequate flow of fresh air from outside the cabinetry to the
base of the hob.
- If the hob is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the hob.
- The isolating switch must be easily accessible by the customer.
BEFORE LOCATING THE FIXING BRACKETS
- The unit should be placed on a stable, smooth surface (use the packaging).
Do not apply force onto any controls protruding from the hob.
