Caple C895IBK, Instruction Manual

GB

If all cooking zones are at “0”, all decimal points in the cooking zone displays are blinking. If a cooking 
zone is “hot”, alternating “H” and “0”.
When the sucepan is removed, the zone switched to the wait mode for 10 minutes. The letter H and 
the simbol   alternate on the display the cooking zone then switches off and the letter H appears on 
the display.

Switching-OFF all cooking zones:

Immediate switching-OFF of all cooking zones can be achieved anytime by means of the ON/OFF 
key. In the stand-by-mode an “H” appears on all cooking zone which are “hot”. All other cooking zone 
displays are not illuminated.

Power level

Cooking zone power can be adjusted to 9 levels, indicated by the symbols “1” to “9” on the 7-segment 
LED displays: The letter “P” on the display means that the cooking zone is working at maximum power. 
The letter “A” stands for automatic heating.

Pan sensor function

This activates automatically if a pan is not placed on the cooking zone within 2.5 seconds from when 
it was switched on.
The symbol   appears on the display.

Boster function

Select the cooking zone and the press the Boster button to enter this operating mode.
The letter “P” appears on the display the power of the zone increases from rated power to a higher 
power for 10 minutes:
Ø160 - from 1400 to 1850W
Ø200 - from 2300 to 3000W
This function may terminate ahead of time if:
- The (-) button for the “P” zone is touched
- If the temperature of the zone or system is too high
- If the pan is removed for more than 10 minutes

Residual heat indicator 

It is meant to indicate to the user that the glass ceramic has a dangerous touch temperature in the 
circumference of a cooking zone. The temperature will be determinated following a mathematical model 
and the remaining residual heat will be indicated by means of “H” on the corrisponding 7-segment-
display.
Heating-up and cooling down will be calculated dependent on:
- the selected setting (“0” to “9”);
- the ON/OFF time of the relays.
After the switching-OFF the cooking zone the respective display shows “H” until the assigned cooking 
zone temperature is mathematically in a uncritical level (

≤ 

60°C).

Protection against unintended switching-ON

-  If the electronic control realizes a continuos operation of key for approx. 10 seconds, it switches OFF 

automatically. The control sends out an audible failure signal for 10 second, so that the user can 
remove the object which has been mistakingly placed onto the operation surface.

  The displays show the failure code “ER03”. If the failure carries on for more than 10 seconds, only the 

code “ER03” will be displayed as long as the failure will be recognized by the electronic control. If 
cooking zone is in the “hot” status, “H” will appaer on the display in alternation with the failure notice.

9