Instruction manual C995i
24
Please keep this instruction manual for future reference
V E N T I L AT I O N R E Q U I R E M E N T S
To ensure adequate ventilation of your induction hob, please ensure the installation requirements
shown in this diagram are followed.
A 5mm gap at the front of the unit must be left, and a minimum 10mm gap must be cut out at the
back of the cabinet to allow air to circulate.
A minimum distance of 50mm must be left between the underside of the hob and the appliance
directly below. If a drawer is installed below the hob, a minimum distance of 50mm must be left
between the underside of the hob, and the contents of the drawer. Over filling the drawer may
effect the airflow. If the drawer is overfilled or the ventilation requirements not followed, this will
void the guarantee.
the
lace
℃
N O T E :
The safety distance between the hotplate and cupboard above the hotplate should be at
least 600mm.
There are ventilation holes around the outside of the hob. YOU MUST ensure these holes are not
blocked by the worktop when you place the hob in position.
The rear wall, adjacent and surrounding surfaces must be able to withstand an temperature
of 90°C.
min. 50mm
min. 10mm
min. 10mm
5mm
min. 20mm
V E N T I L AT I O N R E Q U I R E M E N T S
To ensure adequate ventilation of your induction hob, please ensure the
installation requirements shown in this diagram are followed.
A 5mm gap at the front of the unit must be left, and a minimum 10mm gap
must be cut out at the back of the cabinet to allow air to circulate.
A minimum distance of 50mm must be left between the underside of the hob
and the appliance directly below. If a drawer is installed below the hob, a
minimum distance of 50mm must be left between the underside of the hob,
and the contents of the drawer.
Over filling the drawer may effect the airflow. If the drawer is overfilled or the
ventilation requirements not followed, this will void the guarantee.
