Proper use of refrigerator
6
Operation and precautions for ice maker
Note
:
Connection of water pipes:
please contact the after-sales Service Department of the Company
or professionals to install to avoid any risk.
Warning!
The water pipes must be connected while the machine is switched off. Electric shock may
cause serious injury or death.
Notices!
The water pipe cannot be used where environmental temperature is under 0
℃
, Or it may
lead to freezing.
The water pipe cannot be connected to hot water, which may lead to deformation.
The water pipe should be used in the pressure range 30-100psi.
Lower pressure may cause smaller ice pieces and longer water exiting time.
But higher pressure may damage the filter.
The pipe cannot be connected to drinks, alcohol or other liquids except for water.
1.Turn off the water-tap.
2.Connect water pipe onto the water-tap. The water pipe should be long enough
to prevent the drop-off of the water pipe caused by removing of fridge
freezer.
3.Turn off the fridge freezer.
4.Use a connecting pipe to connect the water pipes behind the fridge freezer
and on the water-tap.
5.To prevent the drop-off or leaking of the water pipes, they must be fixed by
fixed pins.
6.Turn on the water tap to check leakage.
7.
The refrigerator is connected to the power supply and
used normally.
Using the Automatic ice maker/water dispenser
Notices!
The water pipes are used in the pressure range of 30-100psi.
Water softeners may damage the ice maker and must not be
used.
Please check the ice pieces in the storage box when power-
off above 1h. If the ice pieces are thawing and binding together,
please empty them, because the bound ice pieces may cause
Failure of the ice system.
When the ice pieces in the storage box are binding together, It is better to melt it with warm
water rather than smash and take out them with a sharp tool, which may damage the fridge
freezer.
A.
Supply of cold water
1.
Choose the ice/water button on the display board, and make sure the water
indicator turns on.
2.
When the water switch plate is pressed by the cup, the cold water comes out.
3.
When using the
fridge freezer
the first time, water does not come out before
the water tank in the
fridge freezer
is filled up. The normal manner to get water is
pushing and holding the switch plate for 2-3 minutes.
4.
After the water comes out, please discharge water for about 3 minutes to
purge the air and smell of plastic in the water pipe.
5.
When cold water is required, it's better to get some ice before getting water.
6.
When getting water, it is normal for noise of valve to be heard.
Ice maker
5
Proper use of refrigerator
Begin to use
Make sure the
is located properly and stably and understand all safety
considerations.
After unsealing the refrigerator, to fix lower cover on the refrigerator
1. Unpacking (if the door height is uneven, adjust it according to the
adjustment instruction at the lower left corner of the fridge freezer's
right side
plate)
After unpacking, install the bottom decoration cover onto the refrigerator.
2. Switch-on
When switching-on, the
enters the state of factory settings
automatically. This
has the power-down memory function. After
the first switch-on, the
will operate as per the settings at last
power-down.
3. Storing foods.
After switching on and operating for a period of time (about 3-5 hours in
summer), the the
is fully cool. Then, foods can be put in and the
can be used formally.
Tips: after the temperature setting has been changed or new food has
been put in, the inner temperature of the fridge freezer can reach a balance
after a period of time. And the length of the period is determined by the
c h a n g i n g o f t e m p e r a t u r e s e t t i n g , a m b i e n t t e m p e r a t u r e , o p e n i n g
frequency, amount of food in the fridge freezer, etc.
fridge freezer
fridge freezer
fridge freezer
fridge freezer
fridge freezer
fridge freezer
Refrigerator
Though most places in the refrigerator can be kept at
2-8
℃
averagely by adjusting temperature setting, the food
in the refrigerator cannot be kept fresh for a long time.
Therefore, the refrigerator can only serve to store food in
short term.
Adjustment of shelf
According to the need of the food to be stored, the shelf
can be adjusted to a proper height.
To ease the use or adjustment of the shelf, it is designed
for sliding; when cleaning the glass shelf, please pull
the glass shelf in the direction 1 and turn it in the
direction 2 at the same time until it is perpendicular to
the original position, and then take it out at 90
°
in
the direction 3.
Adjustment and cleaning of door tray
Hold two sides of the tray, lift it up in the
①
direction, and
pull it out in the direction
②
.
After cleaning, install the tray in opposite
directions.
The installation place can be adjusted according to the
height of the food.
1
2
3
1
2
