4
Start to Use
We suggest you get a
good knowledge of all the safety precautions and make sure that your
refrigerator has been placed properly in its final position before using.
1.
Unpacking
Please install the decorative cover on the bottom beam of your refrigerator after unpacking and
adjust the front leveling legs to level your refrigerator.
2.
Connecting Your Refrigerator to the Power Supply
Your refrigerator will enter the ex-factory default state after connecting to the power supply
and it will display
a target
temperature for the refrigerator compartment and freezer
compartment.
3.
Modes of Your Refrigerator
You can set your refrigerator in either of the following two ways:
(1)
Smart mode: we suggest you
this mode if you have no special requirements.
select
Your refrigerator will work automatically after you chose this mode.
(2)
Manual mode: You can set the temperature by pressing the temperature adjustment key.
4.
Adding Food To
Your Refrigerator
After the appliance has been switched on for a period of time it should have cooled to the set
temperature (about 3 hours in summer).Once this has been done you can add the food.
Tips: The interior temperature may require a certain period of time to reach balance if
the setting temperature is changed or other food is put into the refrigerator. Such a
period of time depends on the change to the set temperature, the surrounding
temperature, opening frequency, the amount of the stored food and etc.
Refrigerator compartment
Though the temperature-
device
keep most of
adjustment
you can
the refrigerator compartment at an average temperature around
2~8, it fails to preserve the freshness of food for long. As a
result, the refrigerator compartment can be used only for short-
term storage.
l
Use of turnover beam
Please keep strictly to the warnings on the label of the turnover
beam. It is a normal phenomenon that the surface of the
turnover beam is hot. Dews on the surface are also normal in
summer or when the surrounding environment is wet. What you
need to do is to
wipe them away with a clean cloth.
l
Use of water tank
Add pure water or mineral water into the tank other than tap
water (don't put juice, milk or other drinks into the water tank;
otherwise, the pipe may be blocked). Please fill water as soon
as possible if the water level in the tank is low. Generally, the
water filter blocks in the tank
be changed annually, as the
should
case may be.
l
Adjustment of cantilever rack
The cantilever rack could be adjusted to the proper height as
required by food. Please adjust the cantilever rack by following
the arrows as shown in the diagram. Raise it upward first and
then take it out by tilting it upward. During installation, put the
upper end of the fixed leg into one of the upper slots on the
supporting iron first and then put the lower end of the fixed leg
into the third slot on the lower part of the supporting iron.
l
Height adjustment and cleaning of door-mounted bottle
rack
Raise the bottle rack in direction 1. hold it with both hands
and take it out in direction 2. After cleaning, you can install
the rack in the reverse order and you can also adjust the height
of the rack.
1
2
Slot
Adjustment of cantilever rack
Correct Use for Your Refrigerator
l
Food suggested to store in refrigerator compartment
(1)
Cooked food, cans, milk, etc.
(2)
Snack food, food subject to tainting, dairy
products
(3)
Cooked cold meat, sausage
(4)
Fruit, vegetables
(5)
Eggs, butter, cheese
(6)
Cans, seasoning
(7)
Drinks, other bottled food
Freezer compartment
The temperature in the freezer compartment is very low so it
the freshness of
preserves
food
for
. Foods that are to be stored for
could be put in this
long periods of time.
a long time
compartment but not exceed the storage period specified on the packaging of each
of food.
type
NOTE:
You can take out the drawers of the freezer compartment to increase its
capacity and store more food.
l
Food suggested to store in freezer compartment
(1)
The upper drawer of the freezer could be used to store fish, meat, ice-cream and etc.
(2)
Japanese-style ice maker is used to make ice
(3)
Ice storage box is used to store the ice
(4)
The lower drawer of the freezer is used to store fish, meat and packaged poultry meat.
NOTE:
Don't touch the freezer tray directly with hands to avoid injury caused
by the very low temperature.
.
Removing
and installing the lower freezer drawer
(1)
Pull out the lower freezer drawer first.
(2)
Take out the two fixed screws from the partition plate of the lower freezer drawer with screw
driver and then take off the partition plate.
(3)
Take off the rear stopper for the lower drawer as shown by Fig. A.
(4)
Take out the lower drawer body with force as directed by the arrows in Fig. B.
(5)
The installation of the lower drawer body is conducted in the reverse order. You should
install the lower drawer body first and then install the rear stopper for the lower drawer as
shown in Fig. C. Finally, both sides of the drawer shall be connected to the position shown
by the arrows respectively.
(6)
The partition plate is installed into the corresponding slots and then is fixed with screws.
The position of the partition plate for the lower drawer could be adjusted according to your
preference.
Advice: Don't remove the lower freezer drawer if not necessary.
A
B
Correct Use for Your Refrigerator
5
C
Upper end of
fixed leg
Lower end of
fixed leg
Adjustment of
door-mounted bottle rack
Rear stopper for the lower drawer
Lower drawer body
lower drawer
Partition plate for the
Insert into the edge
Align with the slot
Align with
the slot
Positioning hole
for the partition
plate
