5
If the appliance is fitted with a supply cord and a
plug, the appliance has to be put in a place where
the plug can be reached easily.
The use of materials which can burst into flames
should be avoided in close proximity of the
appliance. When frying, please pay particular
attention to fire risk due to oil grease. Being
highly inflammable, fried oil is especially
dangerous. Do not use uncovered electric grills. In
order to avoid possible fire risk, all instructions for
grease filter cleaning and grease deposits removal
should be strictly followed.
NOTE: Two people are needed for the
installation of this product.
Warnings
This appliance is not intended to be used by
young children or infirm persons without
supervision. Young children should be supervised
to ensure they do not play with the appliance.
The air extracted cannot be conveyed through or
into a duct used to let out fumes from appliances
fed by energy other than electric power (eg.
central heating, radiators, waterheaters, etc.). To
evacuate the air outlet, please comply with the
pertaining rules given by competent authorities.
Provide the room with adequate ventilation when
a cooker hood and appliances fed by energy
other than electric power (gas, oil, or coal stoves,
etc.) are used simultaneously.
The cooker hood, when evacuating the extracted
air, could generate a negative pressure in the
room which must not exceed the limit of
0.04mbar, in order to avoid the suction of
exhausts deriving from the heating source.
Therefore the room should be provided with air
intakes to allow a constant flow of fresh air.
If the rating label in the cooker hood
shows
the
symbol , the appliance is built in class II° and it
does not need
any earth connection.
If the rating label in the cooker hood
does not
show the symbol , the appliance is built in class I°
and it
needs
the earth connection. When
performing the electrical connections on the
appliance, please make sure that the current tap is
provided with earth connection and that voltage
values correspond to those indicated on the label
placed inside the appliance itself.
Before carrying out any cleaning or maintaining
operations, the appliance needs to be removed
from the electric grid.
If the appliance is not provided with a non-
separable flexible cable and plug, or with
another device ensuring unipolar disconnections
from the grid, with an opening distance between
the contacts of at least 3 mm, then such
disconnecting devices must be supplied within the
fixed installation.
Installation notes
It is possible to open the glass panels, which cover
the grease filters, by slightly pulling the panel on
a side, as shown on fig. 1
In order to allow the hood to perform correctly, it
is recommended to install the appliance at a
distance of 2000 - 2100 mm from the floor. Before
starting the appliance installation, please check
that all components are not damaged, in such a
case contact your retailer and do not carry out the
installation. Furthermore, please read carefully all
of the following installation instructions.
- For the best performance we recommend a
exhausting pipe with a maximum length not
exceeding 5 meters.
- Limit the number of elbows in the piping, since
each elbow reduces the air capacity of 1 linear
meter. (Eg. if you use 2 x 90 ° elbows, the length
of piping should not exceed 3 meters).
- Avoid abrupt direction changes.
- Use a 150 mm constant diameter pipe for the
whole length.
- Use ducting approved by the local standards in
force.
opening the glass panels
It is possible to open the glass panels, which cover the
grease filters, by slightly pulling the panel on a side, as
shown on fig. 1