35
Fig. 10.3
A
U
T
O
Fig. 10.4
ELECTRONIC CLOCK
(fig. 10.2)
The programmer is equipped with an
electronic clock with an illuminated dis-
play which indicates hours and minutes.
Upon immediate connection of the oven
or after a powercut, three zeros will flash
on the display panel.
To set the hour it is necessary to push
the
button and then the
or
button until you have set the exact hour
(fig. 10.2).
Another way is to simultaneously push
the
two buttons and at the same
time push the
or
button.
Note: The hour setting deletes any pro-
gram.
ELECTRONIC TIMER
The timer program consists only of a
buzzer which may be set for a maximum
period of 23 hours and 59 minutes.
If the AUTO is flashing push the
but-
ton.
To set the time, push the
button and
the
or
until you obtain the
desired time in the panel (fig. 10.4).
Having finished the setting, the clock
hour will appear on the panel and the
symbol will be lit.
The countdown will start immediately and
may be seen at any moment on the panel
by simply pressing the button
.
At the end of the time, the
symbol
will be switched off and an intermittent
buzzer will go off; this can be stopped
by pressing any of the buttons.
SETTING THE FREQUENCY OF THE
AUDIBLE SIGNAL
3 possible sounds can be selected by
pressing the
button.
NORMAL COOKING WITHOUT THE
USE OF THE PROGRAMMER
To manually use the oven, that is, without
the aid of the programmer, it is necessary
to cancel the flashing AUTO by pushing
the button
(AUTO will be switched off
and the symbol
will go on - Fig.10.3).
Attention: If the AUTO is steadily lit (which
means a cooking program has already
been set), the program can be cancelled
and switched to manual by pushing the
button .
If the oven is switched on, you must
switch off manually.
Summary of Contents for CR 13400
Page 47: ...47 ...
