Instruction manual DD901BK 17
Please keep this instruction manual for future reference
C A R E A N D M A I N T E N A N C E
Careful maintenance ensures proper operation and good performances over time.
The hood must be disconnected from the electrical network, both by unplugging the appliance
from the socket and activating the magnetic circuit breaker (safety cut-out), before removing the
metal grease filters. After cleaning operations, replace the metal grease filters as outlined in the
installation instructions.
M A I N T E N A N C E
H OW TO P R O C E E D ?
AC C E S S O RY P R O D U C T S
TO U S E
External surfaces and
accessories
Do not use metallic scrubbers, abrasive
products, or hard brushes.
To clean the external surfaces of the
cookerhood and the light housing screen
use only commercially available household
detergents diluted in water. Then rinse
with clean water and dry with a soft cloth.
Activated charcoal filter with
extractable unit open
After 30 hours of operation, the
downdraft will signal the grease
filter saturation.
The saturation is signaled by the
blinking of the 4 central leds.
To reset, hold down the timer button
S-DD11-L
67
9
8
7
10
11
12
6
5
7
8
9
10
11
12
14
for at least 3 seconds, while the
extractable unit is open.
The grease filters can be washed by hand
or in the dishwasher. These fil- ters need
to be cleaned on a regular basis, because
otherwise they may represent a fire risk.
Refit the grease filters and front panel,
making sure that the panel properly fitted
at the sides so that it it does not cause
the downdraft to stop operating.
Activated charcoal filter
In the recirculation mode, the active
charcoal filter must be replaced
periodically.
To remove the charcoal filter first of all
it is necessary to remove the grease
filter and then pull the plastic key of
the panel itself, in order to disengage it
from its seating.
Follow these steps in reverse order to
insert the active charcoal filter.
Replace the used charcoal filter on an
average of every six months.
