Please keep this instruction manual for future reference
Instruction manual VAP2/3IN1, VAPQ2/3IN1, JOY3IN1
11
Normal Cold Water
98˚ Water from Boiler
Normal Hot Water
2. Screw the 3 flexible hoses into the base of the tap. The red hose connects to the hot water,
the blue hose connects to the cold water, and the longer plain steel hose (1 meter) connects
to the boiling water.
3. Attach the T-piece connector to the Cold mains water supply,
to allow a seperate flow to go direct to the water filter. Using
the Blue tube supplied with the filter, cut it to the appropriate
length and connect this to the T-piece connecter via the push fit
connection. The opposite end can then be attached to the inlet
on the filter head.
4. Follow the instructions supplied with the filter and filter head to ensure it is installed correctly,
and set to the correct setting for the water hardness in your area. Failure to do this will
invalidate your guarantee.
5. The hot & cold tap tails can be connected directly to the hot & cold mains water, and the
boiling water flexi tail can connect to the outlet on the top of the boiler.
6. Attach the Boiler inlet flexi tail onto the valve on the side of the
boiler, and finally, using the remainder of the blue tube, connect
this to the filter head outlet and then to the end of the Boiler
inlet flexi tail using the push fit to threaded adaptor.
98°
C
H