Please keep this instruction manual for future reference
Instruction manual VAP2/3IN1, VAPQ2/3IN1, JOY3IN1
16
2. Screw the Hot & Cold flexi hoses into the base of the hot & cold handle. The red hose
connects to the hot water, the blue hose connects to the cold water. The boiling water
flexible hose connects to the base of the boiling water handle. Each handle then needs to be
connected to the spout via the additional flexi hoses, as shown in the diagram here:
3. Attach the T-piece connector to the Cold mains water supply, to allow
a seperate flow to go direct to the water filter. Using the Blue tube
supplied with the filter, cut it to the appropriate length and connect
this to the T-piece connecter via the push fit connection. The opposite
end can then be attached to the inlet on the filter head.
4. Follow the instructions supplied with the filter and filter head to ensure it is installed correctly,
and set to the correct setting for the water hardness in your area. Failure to do this will
invalidate your guarantee.
5. The hot & cold tap tails can be connected directly to the hot & cold mains water, and the
boiling water flexi tail can connect to the outlet on the top of the boiler.
98°
C
H
