20 Instruction manual Oi363
Please keep this instruction manual for future reference
CLEANING AND MAINTENANCE
- Accurate maintenance guarantees good functioning and long lasting performance.
- Particular care must be made when handling the grease filter panel. It can be removed by
pushing its handle toward the back-side of the cooker hood and turning the filter downwards so
to unfasten it from its slot (Fig.3A). To insert the filter just perform the opposite operation.
- When the appliance is used in recirculating mode, the active charcoal filter (Fig.8Z) needs to
be periodically replaced. The charcoal filter can be removed by removing the grease filter first
(Fig.3A), and by pulling its special plastic tongue until it is unfastened from its slot. Reinsert the
charcoal filter by performing the opposite operation.
- The active charcoal filter can be washed and re-used for up to a maximum 3 years. We
recommend that these are replaced during this period. To purchase replacement charcoal filters
please visit
www.caple.co.uk
- To clean the appliance itself, tepid water and neutral detergent are recommended,
while abrasive products should be avoided. For steel appliances specialised detergents are
recommended (please follow the instructions indicated on the product itself to obtain the
desired results).
- The LED lights must be replaced only by a qualified person.
- If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
To clean the charcoal filters, wash by hand with warm water or in the
dishwasher, and then bake in the oven at 90 degrees for 1 hour.
Fig.8.
Fig.3.
› To clean the appliance itself, tepid water and neutral detergent are recommended, while
abrasive products should be avoided. For steel appliances specialised detergents are
recommended (please follow the instructions indicated on the product itself to obtain the
desired results).
› The LED lights must be replaced only by a qualified person.
› If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualified person in order to avoid a hazard.
