6
7
Instruction manual RBR7
Instruction manual RBR7
Please keep this instruction manual for future reference
Please keep this instruction manual for future reference
-
We do not accept responsibility for any damages that
occur due to ungrounded usage.
-
If the socket does not match the refrigerator plug, it
must be replaced by the manufacturer, a service agent
or similarly qualified persons in order to avoid
a hazard.
-
A specially grounded plug has been connected to the
power cable of your refrigerator. This plug should be
used with a specially grounded socket of 13 amperes.
If there is no such socket in your house, please have
one installed by an authorised electrician.
I N S T A L L A T I O N W A R N I N G S :
-
Prior to installation, ensure that the local distribution
conditions (electricity voltage and frequency) and the
requirements of the appliance are compatible.
-
In order to avoid any hazards resulting from the
instability of the appliance, it must be fixed in
accordance with the following instructions.
-
This appliance is not intended for use at altitudes
exceeding 2000m.
-
During installation the appliance must be completely
disconnected from the mains electricity supply.
-
Do not operate the appliance before it is fully installed.
-
The appliance must be installed by an authorised
technician.
-
Your appliance must be at least 50cm away from
stoves, gas ovens and heater cores, and at least 5 cm
away from electrical ovens.
-
If your appliance is placed next to a deep freezer,
there must be at least 2cm between them to prevent
humidity forming on the outer surface.
-
Do not cover the body or top of fridge freezer
with lace. This will affect the performance of your
fridge freezer.
-
Clearance of at least 150 mm is required at the top
of your appliance. Do not place anything on top of
your appliance.
-
Caple is not responsible for any damage that may
be caused by defective placement and installation by
unauthorised persons.
-
When unpacking the appliance, make sure that it is not
damaged during transportation.
-
Check the appliance for any damage.
-
In the case of any defect; do not use the appliance and
contact your retailer or Caple Service immediately.
-
WARNING: When positioning the appliance, ensure the
supply cord is not trapped or damaged.
-
If the supply cord is damaged, it must be replaced by a
Caple service technician or similarly qualified persons
in order to prevent a hazard.
-
Never touch the power cord/plug with wet hands.
This may cause a short circuit or electric shock.
-
The plug must be accessible after installation.
-
WARNING: Do not locate multiple portable
socket-outlets or portable power supplies at the rear of
the appliance.
