Positioning and installing the appliance
1.
Once the appliance has been unpacked, check the main voltage is the same as that
indicated on the
rating plate.
2.
If the door opening direction is as required,
contine with the installation
. Otherwise,
reverse the
position
of the hinges. To do this, carefully
follow the guide on page 7
When installing the appliance, remember the following:
A
.
Do not install
the appliance
near
any
sources of heat such as heaters, radiators,
ovens,
cookers, etc. or
in direct sunlight.
B
.
Make sure that during the automatic defrost, any water on the back wall of the compartment
runs into the drain channel.
C
.
After the appliance has been placed in its final position, leave it for at least 12 hours before
connecting it to the power supply.
D
.
Make sure that the appliance is working
correctly
before placing any food in it.
WARNING
: DO NOT INSTALL THE APPLIANCE NEAR TO ANY HEAT SOURCES AND LEAVE A GAP OF AT LEAST 5
CM ABOVE IT.
INSTALLATION IN THE TALL UNIT HOUSING
The dimensions of the tall unit housing must correspond to those illustrated
on pages 4 and
5.
I
nsert the appliance in the housing against the side panel adjacent to the opening.
Adjust
the foot until the top panel is not in contact with the unit, and anchor the upper part of the
appliance, using the screws supplied, in the pre-drilled panel over the front fascia. Anchor the
two
bottom brackets to the base of the cabinet and the
center of the appliance to the wall of the unit using the
special brackets. Fix the two bottom feet in the holes in the base of the unit.
A
pply the plastic joint gasket.
Position the door sliders and fix in place. Also clip in the screw cover sections.
Fit and secure the slider blocks to the door.
