Instruction manual SP611 / SP911
Please keep this instruction manual for future reference
12
Remove all packaging
- Remove the packaging with the product in place. Cut off the packing ribbons
and carefully cut open the packaging (do not cut too deeply), remove the
packaging. Check that the product is free from transport damage. Any damage
should be reported immediately to the carrier or retailer. Damage, faults and
missing parts must be reported immediately to the retailer.
Installing the ductwork
- Plan where the ductwork will run between the hood and the outside. The hoods
exhaust vertically but can be ducted to the rear behind the chimney duct through
an outside wall or vertically up through the ceiling to the roof. A short straight
duct run will produce the most air flow. Length and elbows will reduce the
efficiency of the blower.
- Install a roof or wall cap. Connect a 150mm round duct to the cap and work
backwards toward the hood. Ensure joints are completely sealed with duct tape.
Fixing to a wall
- Before mounting the hood, plug in and test all functions for correct operation.
- Remove the filters from the bottom of the hood to prevent damage during the
installation.
- With assistance, hold the hood temporarily in position ensuring the bottom is
above the minimum clearance for the cooking surface. Mark on the wall the
holes for the two mounting screws.
- Drill the holes (A) at the distances indicated. Use the appropriate screws and
screw anchors for your wall type (e.g. reinforced concrete, drywall, etc.). If
necessary, prepare back wall with cross framing for secure installation.
SP611BK-SP911BK - Instruction Manual.indd 12
22/03/2016 15:02
