7
How to remove the oil tank
- After having removed the grease filters and
eventually the charcoal filters, please hold the oil
tank up by one hand and loosen the three handles
by the other hand as showed in (fig.8). Then let the
tank slide downwards taking care in order to avoid
spilling any oil.
How to clean the extractor
- To clean the appliance itself tepid water and
neutral detergent
s
are recommended,
abrasive
products should be avoided
to prevent damage to
the finish
. For steel
parts
special
s
ed detergents
can
be used
(please follow the instructions indicated o
n
the product itself to obtain the desired results).
- Warning!
To
uninstall
the appliance from the
cabinet, remove the fixing screws (fig. 6) using a
screwdriver,
then remove
the grease filters (fig.3)
and the
charcoal
filters if they
have been fitted
(fig. 7).
Push
on the small handle of the springs, which are
inside the built-in unit, with the necessary
force
to
unhook the appliance from the cabinet.
*
NOTE:
If the supply cord is damaged, it must be
replaced by the manufacturer
,
its sevice agent or a
similarly qualified person in order to avoid a
hazard.
Contact Caple Service on 0844 800 3830
or email service@caple.co.uk
Replacement
of the LED
light
bar:
Disconnect the extractor from the electrical supply.
Using an appropriate tool, remove the LED bar
from its seat (refer to Fig. 1
0
), disconnect it
from
the appliance
using the appropriate connector then
substitute it with a LED bar with same
characteristics
and install the light bar back into its
seat .
Summary of Contents for ST521
