6.1.5
．
How to remove the inner fans.
There are four fans inside the cabinet, the upper compartment is on the upper inner
air-duct board, the middle compartment fan is on the middle inner air-duct board,
lower compartment fan is on the air-duct board E, the heater fan is on the lower
inner air-duct board.The fans on inner air-duct boards have same method of removing.
1
）
The process of removing the fan on the air-board E (lower compartment fan)
：
Remove the
shelves( 6.1.1)
→
remove the air-duct board D
( 6.1.3)
→
remove the lower compartment fan.
After removing the air-duct board D,
the fan on the air-board E (lower compartment fan)
（
Fig.5
）
.
2
）
The process of removing the fan on the inner air-board (upper, middle compartment fans and lower
heater fan)
：
Remove the shelves
( 6.1.1)
→
remove the air-duct board A
( 6.1.3)
→
remove the inner
air-duct board
( 6.1.3)
→
remove the fans.
After removing the inner air duct boards, remove four fixing screws of the fan, and remove the fan.
（
Fig.9
）
6.1.6
．
How to remove the sensor
The process of removing the
sensor on the air-duct A
：
Remove the shelves
( 6.1.1)
→
remove
the air-duct board A
( 6.1.3)
→
remove the sensor
After removing the air-duct board A, press out the fixing nails from the back with hard tool,
remove the sensor cover, remove the sensor from the air-duct board and cover.
（
Fig.11
）
Fig.11
Fig.12
The process of removing the sensor on the inner air-duct
：
Remove the shelves ( 6.1.1)
→
remove
the air-duct board A ( 6.1.3)
→
remove the inner air-duct board( 6.1.3)
→
remove the sensor
After removing the air-duct board A, press out the fixing nails from the back with hard tool,
remove the sensor cover, remove the sensor from the air-duct board and cover.
（
Fig.11
）
6.1.7
．
How to remove the LED light
1
）
How to remove the upper LED light
1>The process of removing the upper compartment LED light
：
Remove the shelves
( 6.1.1)
→
remove the upper compartment LED light.
After removing the shelves, prize the light cover by hand, the light PCB was fixed by six
hooks.
(Fig.13 & Fig.14)
.Pull the hooks outward one by one and pull the light PCB down, remove
the LED light.
(Fig.15 & Fig.16)
Fixing nails
Air-duct board
A- lower back
Fixing nails
Inner air-duct board back
Summary of Contents for WC177
