Instruction manual WC6100, WC6100GM, WC6100SS
14
Please keep this instruction manual for future reference
I N S TA L L AT I O N I N S T R U C T I O N S
To install the wine cabinet, place the wine cabinet in an opening with dimensions as shown in
Fig.1. The wine cabinet must be placed on a flat stable surface.
D I M E N S I O N S
600mm
70mm
min 550
mm
560
mm
70m
m
521mm
598mm
585mm
555
mm
22mm
595
mm
Ventilation
min 200cm² in plinth
Once the wine cabinet is in place, it can then be fixed into position. Using the 6 fixing screws,
locate these into the 6 fixing holes on either side of the wine cabinet and along the top rail, and
screw into the carcass (see Fig.2).
D I M E N S I O N S
F I G 1
V E N T I L AT I O N :
-
The ventilated cross section must be at least 200cm2 and the wine cabinet shall be ventilated
from the kitchen plinth.
-
The back panel of the carcass the appliance is installed into shall be removed.
-
Where the decorative grill is used it must be noted that the total area of the grill opening
corresponding to the ventilation cross section shall not be less than 200cm2.
F I G 2
