Waste Disposer Installation Manual
3
1.4.2
Remove the Existing Sink Waste
Remove the existing waste from the sink outlet. Remove the old sealing compound from
the hole and clean the surface. (Figure 1)
Figure 1
Figure 2
Figure 3
1.4.3
Install the Flange into the Sink Hole
The Caple Food Waste Disposer comes
with an assembled mounting flange.
Remove the upper part (see drawing on
Page 2, parts A-G) by opening the upper
mounting ring. Insert a screwdriver into the
mounting lug and hold the lower mounting
ring while you turn the mounting assembly
counterclockwise to remove.
Turn the mounting assembly over and
loosen the three screws to gain access to
the snap ring (G).
Lever off the snap ring with a screwdriver.
Take the bracket apart.
Now you have 4 parts (refer to the drawing
on page 2 for the correct sequence).
Food-Waste-Disposer
4
After cleaning the rim of the sink outlet apply a
thin bead of clear silicone.
Place the sink flange (B) into the hole, applying
pressure while you make the next step.
Place the fibre gasket (C) and triangular-shaped
backup ring (D) on the stem of the top flange, slip
the mounting ring (E & F - with the three screws)
over the top and install the snap ring (G) –
(stopping the flange from moving).
Put on the upper mounting ring (E) and tighten the
screws (F) that hold the assembly together.
Dishwasher Connection
To open the dishwasher inlet (J), tap the end of a
screwdriver handle with a hammer until the
knockout plug breaks loose.
