Instruction manual WDU125
7
Please keep this instruction manual for future reference
»
Using a drill, drill out the entire plug, (see 2A). When knock
out plug falls into disposer, you may remove it or grind it
up when the disposer is used. This will not damage the
disposer in any way, but may take some time to grind).
»
Connect dishwasher hose (see 2B) using hose clamp. Make
sure all plumbing connections are tight and in accordance
with all plumbing codes and ordinances. Run water and
check for leaks.
KNOCK/
DRILL OUT
PLUG
RUBBER
HOSE
DISHWASHER
HOSE
*
AIR GAP
*Air gap may not be required for all
installations. Check local plumbing
codes.
DRAIN
DISPOSER
SUPPORT RING
CUSHION MOUNT
MOUNT RING
SINK FLANGE
SINK FLANGE
GASKET
FIBER GASKET
* REMOVABLE SPLASH
GUARD
2A
2B
3A
READ COMPLETELY BEFORE STARTING
NOTE:
Pay close attention to the order of mount assembly
parts, as they have been correctly assembled by the
factory (see 3A). Also, reference the cushion mount
detail in illustration 3G for the proper position of the
cushion mount.
Try practicing this assembly before you get under the
sink to get the “feel” of how the parts fit together.
»
Disassemble mount assembly from disposer
by turning mount ring to the left (clockwise) and
remove.
D I S H W A S H E R C O N N E C T I O N
If you are utilizing a dishwasher, complete the following procedure. If dishwasher is not to be
connected go on to ‘Installation of mounting assembly’.
I N S T A L L A T I O N O F M O U N T I N G A S S E M B LY
