14
15
Instruction manual Wi3125 Wi3125GM Wi3126
Instruction manual Wi3125 Wi3125GM Wi3126
Please keep this instruction manual for future reference
Please keep this instruction manual for future reference
I N S TA L L I N G T H E H A N D L E
Remove the door gasket on the drilled holes side to install the handle (see below drawing).
Fix the handle to the screws and push the gasket back into place.
Visit our caple website to view a ‘How to video’ at
WWW.CAPLE.CO.UK
I N S TA L L I N G T H E F U L L H E I G H T P L I N T H G R I L L E
Take out the full height plinth grille and the brackets from the accessories box. Fix the brackets
to the cabinet with screws provided and fix both sides of the grille to the brackets with the 2
supplied screws as shown in below diagram.
NOTE:
To be installed
with a 150mm plinth
height.
If you wish to reduce
your plinth height, the
smaller, slot-on plinth
grille (see page 16)
should be used.
NOTE:
Full height plinth grille only included with Classic Wine Cabinets WI3125 & WI3125GM.
1. Open the door to 90 degrees, take out 2 screws (2) from lower door axis (3), remove the
door (4), then pull out the door and door axis (Fig. A).
2. Put the door down safely and take out the plug (12) from top of door frame, unscrew 1
screw (11) at bottom and remove the door limit device (10), then install the door limit
device (10) at top of door frame, please use spare plug (12) to block the hole at top of
door frame. (Fig. A/B)
3. Take out 3 hinge screws (6) from top hinge (right) (5) and remove it. (Fig. C)
4. Remove decorative nail (8) from left top of cabinet and install spare top hinge (Left) (7) at
left top of cabinet with 3 screws. (Fig. D)
5. According above procedure, install spare lower hinge (left) (9). (Fig. E)
6. The door revolves 180 degrees, install the door with same way it was removed and fix it
with door aligned.
7. Block the hole at right top of cabinet with spare decorative plugs (8).
Scan the QR code below to
access the ‘How to video’
