C 1400/E17DF
11
Open the door of the safe.
Open the battery compartment and insert 4 x AA 1.5V batteries.
If both of the red and the green lights are on at the same time, it means the voltage is low and you should insert
new batteries.
CAUTION: Replace 4 fresh batteries by lining them up in a manner as indicated by the “+” and “-“ signs. When
outage for longer than thirty minutes, you should reset the user’s code.
Open the safe and press the reset button (red button) located inside the battery compartment, the yellow lights
goes on.
Input new code (3-8 digits), and press the “C” or “E” button to confirm, then close the safe.
If the yellow light flashes with 3 buzzer beeps, which means the code changing is not effective, and you need to try
again.
CAUTION: The user preset code is “159”. Please input the user code again if the yellow light flashes with three
buzzer beeps.
Input your user’s code (3 to 8 digits), each pressing results one buzzer beep and yellow light flashed.
Press “C” or “E” button to confirm the code, the green light will be on.
Rotate the knob (master key) clockwise and pull outwards within 5 seconds, the door is opened.
CAUTION: 3 continuously wrong entries will activate the warning beep for 20 seconds.
The key pad would be disabled during the beeping. You can only stop the beeps by opening the safe with emergency
key and power-cut by removing the battery.
Turn the knob (master key) anti-clockwise to close the door.
INSERTING THE BATTERIES
SETTING THE USER CODE
CLOSING DOOR
OPENING DOOR
CLOSING DOOR
CLOSING DOOR
