30
© Erwin Hymer Group North America, Inc., R00
Shower Setup:
The Carado comes with a rear washroom/toilet area. It takes several steps to create the washroom. An outline to those steps is as follows:
*Please refer to pictures starting on page 31.*
The sliding shower door is held in place by a clear plastic strap and button snap. (Picture 31.1 Next Page)
Open the storage cabinet door (left side) directly opposite the sliding shower door to reveal catch magnets on the inside of the door at the top and
bottom. (Picture 31.2 Next Page)
Unsnap sliding shower door strap and slide shower door across washroom until magnets on shower door arm catch magnets attached to storage
cabinet door. (Picture 31.3 Next Page)
Slide shower curtain all the way around enclosing the washroom area. (Picture 31.4 Next Page)
Unscrew the drain stopper from the bathroom floor and store for safe keeping. (Picture 31.5 Next Page)
When finished showering, air dry or wipe off sliding shower door and shower curtain before securing.
Taking A Shower
•
To take a shower, unscrew the drain stopper in the bathroom floor and store for safe keeping and reinstallation after your
shower.
•
Release loop fastener straps retaining the shower curtain and slide the shower curtain along its track to enclose the shower
space.
•
Pull the faucet/showerhead up and adjust the water temperature as desired. There is a water cutoff on the handle to
conserve water.
•
When finished, either towel off or air dry the curtain and sliding shower door before storing it.
•
Refasten the drain stopper to prevent the contents of the waste tank from sloshing up into the shower area while driving.
